Learn how Dragonfly contributed to a research project…


Resources / Publications

Scientific Publication Citing Dragonfly

Pore space characteristics and corresponding effect on tensile properties of inconel 625 fabricated via laser powder bed fusion

Mehrnaz Salarian (1), Hamed Asgari (1), Mihaela Vlasea (1)
Materials Science and Engineering: A, 769, 2020. DOI: 10.1016/j.msea.2019.138525


Laser powder bed fusion, Inconel 625 alloy, X-ray computed tomography, Tensile behavior, Pore space characteristics


In this work, the tensile behavior of Inconel 625 parts fabricated via laser powder bed fusion (LPBF) at differentlaser power levels is examined, and correlated to bulk porosity as well as pore characteristics such as pore size,aspect ratio morphology, and polar orientation extracted from X-ray computed tomography (CT). Scanningelectron microscopy (SEM) is employed to identify the fracture mode and origin of failure in the pulled samples.Microstructural examination on the as-built samples showed that increasing the laser power resulted in thetransition of melting mode, from lack of fusion to keyhole, with an increase in part bulk density from 98.86% to99.29%, respectively. It was found that the general bulk porosity level does not correlate directly with the UltimateTensile Strength (ranging between 780–820 MPa) and strain to fracture (ranging between 0.2–0.39)behavior of the parts. Detailed pore space characteristics obtained from CT datasets before and after the tensiletest contributed to establishing a relationship between defects size, morphology, orientation and tensile propertiesof the samples. In general, it was found that strain to failure is directly influenced by pore space characteristics,while tensile strength is influenced by a combination of pore space and microstructuralcharacteristics. This study also identified that there are systematic bias effects in the LPBF process, likelyintroduced by the combination of nuisance variables such as powder layer spreading and gas flow.

How Our Software Was Used

Dragonfly was used to perform advanced image processing and porosity analysis.

Author Affiliation

(1) Multi-Scale Additive Manufacturing (MSAM) Lab, Department of Mechanical and Mechatronics Engineering, University of Waterloo, Waterloo, ON, Canada.

Return to Publications list.

Have a Publication to Share?

We'd be pleased to add your paper to our publications list.