Resources / Publications
Salah Eddine Brika(1), Morgan Letenneur(1), Christopher Alex Dion(2), Vladimir Brailovski(1)
Additive Manufacturing, 31, 2020. DOI: 10.1016/j.addma.2019.100929
Laser powder bed fusion, Particle size distribution, Sphericity, Ti-6Al-4V, Layer thickness,Powder flowability
Laser powder bed fusion (LPBF) additive manufacturing technology is sensitive to variations in powder particle morphology and size distribution. However, the absence of a clear link between the powder characteristics and the LPBF performances complicates the development, selection and quality control of LPBF powder feedstock. In this work, three Ti-6Al-4 V powder lots produced by two different techniques, namely, plasma atomization and gas atomization, were selected and characterized. Following the micro-computed tomography analysis of the powder particles’ morphology, size and density, the flowability of these powder lots was concurrently evaluated using Hall and Gustavsson flowmeters and an FT4 powder rheometer. Using established rheology-based criteria, a figure of merit was proposed to quantify the overall powder suitability for the LPBF process. Next, the same three powder lots were used to 3D-print and post-process a series of testing specimens with different layer thicknesses and build orientations, in order to establish a correlation between the powder characteristics and the geometric and mechanical properties of a final product. This study demonstrates that the use of highly spherical powders with a limited amount of fine particles promotes their flowability and yields LPBF components with improved mechanical and geometric characteristics.
Dragonfly was used to analyze a plastic capillary filled with powder, allowing the isolation of powder particles, the generation of their 3D representations and the calculation of several metrics of interest for each of them.
(1) Department of Mechanical Engineering, École de technologie supérieure, 1100 Notre-Dame Street West, Montreal, QC H3C 1K3, Canada.
(2) Research and Development, PyroGenesis Additive, 1744, William St., Suite 200, Montréal, QC H3J 1R4, Canada.
Return to Publications list.